Installing Flush Mount Lighting Fixture – Flush mounting fixtures is a potentially inexpensive way to decorate a room. You can decide right and basic or decorative and fancy. Watch your favorite home improvement stores or on the internet to find the fixture in your dreams. You will discover there are thousands of designs to consider.
How to install flush mount lighting fixture, Lucky power to the circuit you will be working on. Never work on an electrical project with the power on. Dismantle and remove the old fixture, if it exists. If there is someone present fixture, pulling the wires out of the electrical box and straighten the wires. Strip 5/8 inch of insulation from the ends of the wires. Place the fixture on a flat surface. Measure the height of the dome of the fixture. Let us say that this measurement is 6 inches. Adjust the threaded tube in the assembly line to a length of 6 1/8 inches. The dome is held by the threaded pipe and must reach the fixture and the dome to keep the dome in place.
Remove the screws from the electrical box in the ceiling to install a flush mount lighting fixture. Attach the mounting strap and threaded pipe and attach the ground wire to the green screw on the mounting strap. Keep equipment up to the electrical box. Wrap the black wire to the black wire and the white wire to the white wire. Wire nut these wires together. Place the retaining washer over the threaded tube and wire nut over the pipe until the fixture is flush against the ceiling. Some fixtures use screws that attach the electrical box. Install the light bulbs and place the dome over the fixture. Tighten the decorative nut over the threaded pipe. Turn on the circuit back and test fixture functionality.