Twin car bed – Sand both faces of a plywood sheet with coarse, then fine sandpaper. Paint both faces of plywood with white paint. Allow to dry. Download a profile picture of a car to your computer using a free image bank you like. Set up your plywood sheets so that it rests on its 80-inch long. Set up the projector so it projects the car image on the white plywood sheets. The image should be at least 75 inches wide to customize the length of the bed.
Use colored paint and / or markers to draw the projected image on plywood sheets. Use as much or as little detail and precision that the child wants. Repeat it to complete the other side of the bed. Cut car shape out of the plywood sheet using the jigsaw. For twin car bed frame assembly. Attach a 72-inch beam inside (unpainted) meet with a plywood panel car. The beam should run parallel to the length of the panel, the 12 inches from the bottom edge. Screw it into place.
18 Photos Gallery of: Build Twin Car Bed Frame
Repeat steps with the remaining beam and the second plywood car panel. Connect panels by setting 1:39 -inch beam so that it touches one end of the 72-inch beams. Screw it. Connect the free ends of the 72-inch beams using the remaining 39-inch beam. Use touch-up paint to the exterior (painted) faces of plywood car panels, covering up the screw heads. Push the box spring in place on the frame formed by the beams. Set over mattress on top of box springs. Twin car bed was done.